Contec CMS60C User Manual

12
thiosalicylic hemoglobin, and some with icterus problem, the SpO
2
determination by this monitor
may be inaccurate.
C
C
C
C .
.
.
. The drugs like dopamine, procaine, prilocaine, lidocaine and butacaine may also be a major
factor blamed for serious error of SpO
2
measure.
D
D
D
D .
.
.
. As the SpO
2
value serves as a reference value for judgement of anemic anoxia and toxic anoxia,
some patients with serious anemia may also report good SpO
2
measurement.
7
7
7
7 M
M
M
M aintain
aintain
aintain
aintain 、 transportation
transportation
transportation
transportation and
and
and
and storage
storage
storage
storage
7.1
7.1
7.1
7.1 Cleaning
Cleaning
Cleaning
Cleaning and
and
and
and Disinfecting
Disinfecting
Disinfecting
Disinfecting
Using medical alcohol to disinfect the device, nature dry or clean it with clean soft cloth.
7.2
7.2
7.2
7.2 Maintain
Maintain
Maintain
Maintain
A.
A.
A.
A. Please clean and disinfect the device before using according to the User Manual(7.1).
B.
B.
B.
B. Please recharge the battery when the screen shows .
C.
C.
C.
C. Recharge the battery soon after the over-discharge. The device should be recharged every six
months when it is no regular used. It can extend the battery life following this guidance.
D.
D.
D.
D. Please take out the batteries if the oximeter is not in use for a long time.
E.
E.
E.
E. The device needs to be calibrated once a year (or according to the calibrating program of
hospital). It also can be performed at the state-appointed agent or just contact us for calibration.
7.3
7.3
7.3
7.3 Transportation
Transportation
Transportation
Transportation and
and
and
and storage
storage
storage
storage
A.
A.
A.
A. The packed device can be transported by ordinary conveyance or according to transport contract.
The device can not be transported mixed with toxic, harmful, corrosive material.
B.
B.
B.
B. The packed device should be stored in room with no corrosive gases and good ventilation.
Temperature: - 4 0 ° C~ 60 ° C ; Humidity: ≤ 95%
8
8
8
8 Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Trouble
Trouble
Trouble
Trouble Possible
Possible
Possible
Possible Reason
Reason
Reason
Reason Solution
Solution
Solution
Solution
The
The
The
The SpO
SpO
SpO
SpO
2
2
2
2
and
and
and
and Pulse
Pulse
Pulse
Pulse
Rate
Rate
Rate
Rate can
can
can
can not
not
not
not be
be
be
be
displayed
displayed
displayed
displayed normally
normally
normally
normally
1. The finger is not properly positioned.
2. The patient ’ s SpO
2
is too low to be
detected.
1. Place the finger properly and
try again.
2. Try again ; Go to a hospital for
a diagnosis if you are sure the
device works all right.
The
The
The
The SpO
SpO
SpO
SpO
2
2
2
2
and
and
and
and Pulse
Pulse
Pulse
Pulse
Rate
Rate
Rate
Rate are
are
are
are not
not
not
not
display
display
display
display ed
ed
ed
ed stabl
stabl
stabl
stabl y
y
y
y
1. The finger is not placed inside deep
enough.
2. The finger is shaking or the patient is
moving.
1. Place the finger properly and
try again.
2. Let the patient keep calm
The
The
The
The device
device
device
device can
can
can
can not
not
not
not
be
be
be
be turn
turn
turn
turn ed
ed
ed
ed on
on
on
on
1. The battery is drained away or almost
drained away .
2 . The battery is installed incorrectly.
3. The malfunction of the device.
1. Please recharge the battery
2. Please Install the battery
again.
3 . Please contact the local service
center.

Contec CMS60C Specifications

General

Brand	Contec
Model	CMS60C
Category	Medical Equipment
Language	English