Conti X-one - HOT WATER DOSE PROGRAMMING

Edition 05/2014 - X-ONE - page 12
SACOME, CONFIDENTIAL Document, it is forbidden to duplicate or communicate this document without previous authorization.
7.4 HOT WATER DOSE PROGRAMMING:
«Hot water» key
Methodology:
7.4.1 X-One
One programming dose is available:
• Press key n°5 (MENU) from the 1st group during 5 seconds.
• Display shows « Press dose selection within 30s ».
• Push hot water key to start the flow, and push again when the water volume is correct.
• You can use hot water key after the message «Press dose selection within 30s» disappears.
7.4.2 X-One TCI
Two programming doses are available, for 2 different volumes: 1x short and 1x long.
• Press key n°5 (MENU) from the 1st group during 5 seconds.
• Display shows « Press dose selection within 30s ».
• Push the 1
st
key “short hot water” to start the flow, and push again when the water volume is correct
(for exemple 1 cup of tea).
• Do the same operation, within a maximum of 30 sec, on the 2
nd
key “long hot water” available.
• You can use hot water key after the message «Press dose selection within 30s» disappears.