Edition 05/2014 - X-ONE - page 13
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.
7.5 AUTOMATIC CLEANNING OF COFFEE GROUP :
The cleaning of coffee group is made group by group, preferably at the end of service, before the machine is
stopped or put in "ECO" mode, using this specific function managed by the machine.
The procedure for cleaning coffee groups is as follows:
Remove the filter-holder from the group and clean the seal with the supplied brush.
Insert blind filter (provided with the machine) in the filter-holder.
Put a detergent tablet (CONTI brand code: 466662) in the blind filter, and engage the filter-holder in the
group.
Keep pressing key n°5 (MENU), then press the key n°1 (1 espresso).
The cleaning process starts automatically, with a 1st step of 10 “ON and OFF” cycles. (The display shows
« cleaning in progress »). The purpose is to disolve the tablet, and release the cleaning agent on the coffee
group circuit and on the coffee valve.
Then this step stops for a 2
nd
step. (The display shows “Wait”). The machine waits for 1 minute in order to
make the product acting.
Release the filte- holder from the group and rinse it under water.
Then, the 3rd step, is a rinsing during 20 seconds. (The display shows “rinsing”).
When the cleaning cycle is finished, the message disappears, and the group available again.
Repeat this operating mode on each group, and each time the message « cleanning Grp i SVP » appears
on the display.
The cleaning cycle can be interrupted, pushing any key of the concerned group. But, you will lost the
following steps, and will compromise the cleaning efficiency.
It is possible to perform an automatic washing cycle for each group independently
7.6 ECONOMIC MODE :
The evening or before a long period of inactivity, the economic mode allows to keep the machine in standby
The display shows "ECO”.
Then the boiler is maintained at a temperature of 60 ° C:
• which saves energy during the temperature drop
• and also during the standby period because the set-point temperature is low.
The output of "ECO" mode allows the machine to come back quickly to its operating parameters without
spending lot of energy.
To Next Page
Loading...
