2. Calibration Gyroscope
4. Operating Method
3. Take-off / Landing
Note: One button landing must land on a level surface, if not it will cause the drone to fly off course.
After the drone and the remote control are connected successfully, push the left and right
joystick to the lower right corner. At this time, the indicator light will flashes rapidly and change
to a steady light. The calibration is completed.
Drone needs to unlock before flying, push the left joystick up then release it. At this time, the
propellers starts to spin. Push the left joystick up again or press the one key take-off / landing
button, the drone will rise to a height of about 1 meter and hover.
Pull the left joystick down or press the one key take-off / landing button again and the drone will
land.
Note: If the drone flies unstably after takeoff, it can also be corrected by calibrating the
gyroscope. The calibration should be done at the horizontal level.
To Next Page
Loading...
