Note: The product has the function of air pressure fixing height, but does not have the effect of
fixed point. The drone will move slightly at the same height when hovering in the air.
12. Trouble Shooting
11. Install the Propellers
Align the blades with the motor shaft and install them (the arm identification must be consistent with the
blade identification). Tighten the screw clockwise.
Drone does not respond
to user controls.
The blades spin, but the
drone cannot take off.
The drone shakes
heavily.
Drone does not stabilize
during flight with fine tuning.
1. The blades distorted.
2. Defective motor.
The blades distorted. Replace the blades.
1. Replace the blades.
2. Replace the motor.
1. Remote is not synced to
the drone.
2. Insufficient battery power.
1. Refer to page 9-10 (Flight).
2. Recharge the battery.
1. Recharge the battery.
2. Replace the blades.
Problem Cause Solu�on
1. Insufficient battery power.
2. The blades distorted.
3. The blades Side A and Side
B are reversed.
Drone cannot takeoff after
accident.
Four-axis acceleration sensor
loses balance.
Recalibrate compass.
CONTACT INFORMATION
E-Mail: support@con�xo.com
Website: www.con�xo.com
©2023 Con�xo Inc. All rights reserved. Con�xo®, the Con�xo logo and
associated characters, trademarks and design elements are owned and
licensed by Con�xo Company.
To Previous Page
Loading...
