Commander SE User Guide 64
Issue Number 8 www.controltechniques.com
•Pressthe STOP key to STOP the drive. The display should show:
3. If the drive trips during these tests the display will show, for example
The right hand display will flash with the trip code
4. Press the RESET buttontoresetthetrip.Pressthe RUN button to run
the drive.
5. The FORWARD/REVERSE button can be enabled by setting parameter 26 =
On.
If this test has been carried out as a bench test and the drive is to be connected to
a different motor with different characteristics etc. in the application, then the
motor map parameters should be set to the correct values for the new motor and
another autotune carried out (see parameter 38 for details).
rd
0.0
tr
OU
NOTE
To Next Page
Loading...
Need help?
General
