Control Techniques Unidrive HS30 User Manual

Unidrive M300/HS30 Quick Start Guide 29
Issue Number: 7
* Setting Pr 07 to 0.0 will disable slip compensation. With the Unidrive HS30, the maximum is 80,000.0 rpm.
** Following a rotating autotune, Pr 09 is continuously written to by the drive, calculated from the value of Stator
Inductance (Pr 05.025). To manually enter a value into Pr 09, Pr 05.025 will need to be set to 0. Refer to the
description of Pr 05.010 in the Parameter Reference Guide for further details.
*** With the Unidrive HS30, the maximum is 3000.00 Hz.
**** If this parameter is read via serial communications, it will show pole pairs.
***** With the Unidrive HS30, the maximum is 180,000.0 rpm.
93 Jog Select Off (0) or On (1) RO Bit ND NC PT
94 Analog Input 1 ± 100.00 % RO Num ND NC PT FI
95 Analog Input 2 ± 100.00 % RO Num ND NC PT FI
RW
Read /
Write
RO
Read
only
Num
Number
parameter
Bit
Bit
parameter
Txt Text string Bin
Binary
parameter
FI Filtered
ND
No
default
value
NC
Not
copied
PT
Protected
parameter
RA
Rating
dependent
US User save PS
Power-down
save
DE Destination
Parameter
Range
(Ú) Default (Ö)
Type
OL RFC-A OL RFC-A

Control Techniques Unidrive HS30 Specifications

General

Brand	Control Techniques
Model	Unidrive HS30
Category	Controller
Language	English