Need help?Do you have a question about the Control Techniques Unidrive 1403 and is the answer not in the manual?
General| Model | Unidrive 1403 |
|---|---|
| Protection Class | IP20 |
| Input Voltage | 380-480V AC |
| Output Voltage | 0-480V AC |
| Communication Options | Ethernet, Profibus, CANopen |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit |
| Operating Temperature | 0°C to 40°C |
| Humidity | 95% non-condensing |
Warning about severe electrical shock and lethal voltages.
Drive as a component, safety hazards, installation by trained personnel.
Details of 200V and 400V drive ratings, including output currents and input currents.
Follow instructions, competence of installer, isolation device, stored charge.
Details for connecting power to Unidrive size 1 to 2, including safety warnings.
Specifies voltage, phase, frequency, and imbalance requirements for AC supply.
Output circuit protection, motor and cable overload, and thermistor protection.
Information on braking resistor values and power ratings.
Compliance with EN61800-3 standard for Power Drive Systems.
Procedure to change the drive's operating mode and reset parameters.
Step-by-step commissioning for Open loop, Closed loop vector, and Servo modes.
Parameters for open loop, closed loop vector, and servo motor control.
Details on drive power and current ratings, including tables for different models and frequencies.
Details of drive power and current ratings, including continuous and typical input currents.
Lists drive trip codes, their diagnosis, and related parameters.
To Next Page