Controlotron 1010PVDN - 2.11.7 Troubleshooting Tips; Flow Computer Messages

1010PVNFM-3A
Table Of Contents
v
2.11.10 Using The 996PSP Pipe Simulator ............................................................. 2-86
If a Pipe Simulator/Test - Block Test Fails ........................................... 2-87
2.12 Guide To A Smooth Installation .................................................................. 2-88
2.12.1 Checklist For 1010 Start-up & Performance ........................................... 2-88
Programming ............................................................................................ 2-88
Installation/Transducer Mount Guidelines ........................................... 2-88
Start-Up ..................................................................................................... 2-89
Diagnostic/Performance Verification ..................................................... 2-89
2.12.2 Optimization/Correction Of Problems ............................................. 2-89
Incorrect “Measured Vs” ......................................................................... 2-89
Low Valc ....................................................................................................2-90
Detection Fault/Low Signal.....................................................................2-90
High Vaer ..................................................................................................2-90
Poor Signal ................................................................................................ 2-91
“Official” Coupling Compound ................................................................ 2-91
“Alternative” Coupling Compound ......................................................... 2-91
Ideal Vsig Display .................................................................................... 2-91
Section 3
3. Hardware Installation Guide .......................................................................3-1
3.1 Preparing To Mount The Transducers....................................................... 3-1
3.1.1 How To Identify 1011 Transducers and Mounting Hardware .............. 3-1
3.1.2 Selecting A Location For Clamp-On Transducers ................................... 3-1
3.1.3 Clamp-On Transducer Mounting Modes................................................... 3-2
3.1.4 Preparing The Pipe......................................................................................... 3-3
3.1.5 Reflect Mode With EZ Clamp And Spacer Bar Only ...............................3-4
3.1.6 Direct Mode With EZ Clamp And Spacer Bar Only ................................. 3-5
3.1.7 Reflect Mode-Mounting Frames and Spacer Bar ....................................3-9
3.1.8 Reflect Mode With Spacer Bar Only ...........................................................3-10
3.1.9 Direct Mode-Mounting Frames, Spacer Bar and Spacing Guides ....... 3-12
3.1.10 Using 1012T Mounting Tracks ...................................................................... 3-16
Installing a 1012T Mounting Track in Reflect Mode .............................. 3-16
Installing a 1012T Mounting Track in Direct Mode ............................... 3-18
3.2 Mounting Temperature Sensors .................................................................. 3-20
3.2.1 Wiring Temperature Sensor To The Analog Input Module ................... 3-21
3.2.2 1010PVN Supply And Return Connections .............................................. 3-22
3.2.3 Notes On System 1010 Analog Input Modules .......................................... 3-23
Single Channel Models ............................................................................ 3-23
Double Channel Models ........................................................................... 3-23
3.2.4 Clamp-On RTD Installation Notes ..............................................................3-24
Section 4
4. The Meter Facilities Menu And Graphic Display Screens .................... 4-1
4.1 Preferred Units ................................................................................................ 4-1
4.2 The Table Setups Menu .................................................................................. 4-2
4.2.1 Pipe Table .........................................................................................................4-2
Pipe Table Menu Structure ...................................................................... 4-2
4.2.2 Create/Edit Pipe ..............................................................................................4-3
4.2.3 Delete Pipe ........................................................................................................4-4
4.3 Transducer Type Menu .................................................................................4-4