2-40
1010PVNFM-3A
Section 2
To edit the Display Range:
To access the [Display Range] option list press
To move the cursor to the required display range press
To store selection press
2.6.4 FLOW DISPLAY SCALE
After you select rate units, the meter automatically computes a prefix to provide the best
combination of capacity and resolution (e.g., KGAL/MIN). The [Flow Display Scale] menu cell
shows the results. If the displayed scaling is not suitable, you can edit it by accessing the
option list. Note that this scaling applies to all flow rate data displayed on the flow display
screen, even if the units do not appear next to the data (because there may not be room on the
screen). Therefore, always keep this prefix in mind when you enter flow related data.
To select a different Flow Display Scale:
To access the [Flow Display Scale] option list press
Move the cursor to the desired display scale by pressing
To register selection press
2.6.5 TOTAL VOLUME UNITS
This menu cell allows you to select which units the meter uses for the flow total output. If you
select mass units, the meter uses the specific gravity parameter (see paragraph 2.4) to convert
volumetric flow to mass flow. The default English Flow Total Units is [Gallons] US]. If this
suits the application, press the <Down Arrow> to bypass this menu cell.
To change the default setting:
To access the [Total Volume Units] option list press
To move the cursor to the desired Total volume units press
To store selection press
ENT
ENT
ENT
To Next Page
Loading...
