10
MANUAL STARTING
RUN BUTTON
Press the green RUN button. If a preheat cycle is programmed in the display, or requested by the
engine’s ECU, the status line will indicate a Wait to Start message or Preheat Countdown. Once
completed, the status line will show Ready to Start.
Press and Hold the green RUN button. The status line will display Starting Engine. The module will
energize the crank output or send the J1939 CAN Start Engine command depending on the engine
manufacturer selected. Once the engine has started, the crank circuit will be de energized even if the
button is continued to be pressed.
To Next Page
Loading...