38
PUMP PARAMETERS
If the four analog senders are configured for pump use, the values can be seen here. Note, you must
select either Application Level or Application Pressure when configuring the transducers.
OPERATION EVENT LOG
The module will record the last 32 operational events and show the most recent first. The event log
can be cleared in the Module Configuration menu of the Controller Setup area.
ALARMS EVENT LOG
The module will record the last 32 Alarm events and show the most recent first. What is different
about this log when compared to the Stored Code list is that the Alarm Log will record both the ECU
codes and module monitored events, such as low fuel level or other non-ECU monitored events. This
paints a more complete picture of what is occurring at the engine while troubleshooting. This log can
also be cleared under the Module Configuration menu.
To Next Page
Loading...
Need help?
General
