Convaid CuddleBug - Setting Up; Unfolding

1. Lay chair down with seat
facing upward. Fig. 1
2. Push in grey detent buttons
on the footplate, and swing
footplate out and upward
until parallel with the ground.
Fig. 2
3. Squeeze the recline lever
on the right side of the
chair’s handle and lift seat
back into full upright
position. Fig. 3
CONVAID USER’S GUIDE
1
Setting Up
Unpacking
Unfolding
Check to see that the following items are included with the chair:
• Left and right footplates.
• Accessories as ordered.
• Hex wrench (5/32”).
SIZE / MODEL
CHART
CuddleBug
Size Model No.
1 CB-size 1
2 CB-size 2
Caution:
Keep fingers
free of folding
mechanism.
!
Fig.1
Fig.3
Fig.2