Conviron ADAPTIS Series - Maintenance

May 2009 | Revision 6.0
1-6
CHAPTER 1.0 | PRECAUTIONS
1.3 Maintenance
Unit Clean
Water Reservoir
Lights
Inside the Adaptis cabinets there are sensors
and other electrical components. Never
water the unit’s interior directly using a hose.
For interior cleaning please damp a clean
towel or rag outside the unit, and carefully
wipe the unit down. Do not use abrasive
cleaners. Detergents in low proportions are
suitable for most cleaning requirements.
Adaptis A350 will require maintenance of the
glass windows. Use glass cleaners in both
sides (interior and exterior).
If the water system is not going to be used for
a long period of time, purge the water tank
located in the mechanical compartment. To
do so:
• SHUTTHECHAMBEROFF(withtheswitch
button located between the door and
front panel).
• Liftthetopcover,turnthebreakeroff,
and disconnect the ground wire at the
back of the top cover.
• Carefullyremovethetopcover.
• Openthewaterreservoirlid.
• Cleanthewatertank.
• Makesuretherearenotwaterresidues
over the ultrasonic discs.
• Placethewaterreservoirlidback(this
is very important otherwise air from the
unit will be damped into the ambient
at all times, and water may be splashed
over electrical components).
Periodically check to ensure all lamps
functioning properly. Replace poorly lit
or flickering lamps to ensure optimal unit
performance.