3.
Vertically push the bottle into the pointed tip at the center
of the cooking compartment drain so that the tip will
pierce the seal.
4.
Let the bottle sit vertically on the pointed tip for about
10 seconds so that there will be enough time for all the
liquid to come out.
Visually check whether all the liquid has come out.
The single-measure dispensing bottle is made of a
transparent material that makes it possible to see
whether there is any liquid still inside.
If necessary, squeeze the remaining liquid out of the
single-measure dispensing bottle while it is still on the
pointed tip.
5.
Once you are done, carefully remove the bottle from
the pointed tip.
Remove the bottle from the cooking compartment.
Repeat steps 2 through 5 if the software prompts you
to use more than one single-measure dispensing
bottle to add cleaning agent or rinse aid to the inside
of the cooking compartment.
WARNING! Risk of food being contaminated by cleaning
agent or rinse aid
Make sure that the work surface does not come into
contact with cleaning agent or rinse aid.
Do not put empty single-measure dispensing bottles
down on the work surface, as drops of cleaning agent
or rinse aid may run down along the outside of the
bottles.
6.
Close the appliance door.
5 How to Clean the Combi Steamer
Operating Manual 102
To Next Page
Loading...
Need help?
General
