5.3.2 Replacing the Rinse Aid Canister
For your safety when using the appliance
Before starting work, read and understand the rules, risks, and hazards specified in “
Safely Using the
Appliance
on page 97” and follow all the corresponding instructions without exception.
Required tools
One empty canister (10 l) for ConvoCare rinse aid
Enough (around 10 l) soft water (for specifications, please refer to the
“Water Quality”
sub-section
of the
“Technical Data”
section in the installation manual)
ConvoCare K concentrate (0.33 l)
Preparing ConvoCare rinse aid in the canister
To prevent undesired foaming, follow the steps below when preparing rinse aid with ConvoCare K
concentrate and soft water:
1.
Open the empty canister (1).
2.
Fill the canister with soft water (2) all the way to just
under the 10-liter marking (4).
3.
Then carefully pour 0.33 l of ConvoCare K concentrate
(3) into the canister (1).
4.
Check the liquid level inside the canister:
If the level is below the 10-liter marking (4), carefully
add the required amount of soft water (2).
If the level is above the 10-liter marking (4), the rinse
aid’s concentration will be lower than specified. You
can still use the rinse aid if this is the case!
5.
Close the canister and mix the liquids thoroughly by
shaking it.
Replacing the rinse aid canister
1.
Remove the cap from the canister in which you prepared
ConvoCare rinse aid.
2.
Find the canister that is connected to the rinse aid
connection (F) with a (green) tube and that is located
on the bottom left side of the appliance.
Unscrew the (green) supply tube (2), together with the
wand, from the canister you just identified.
Remove the empty rinse aid canister.
5 How to Clean the Combi Steamer
Operating Manual 98
To Next Page
Loading...
Need help?
General
