3.
Put the new, full canister (1) containing rinse aid in
place.
Insert the (green) supply tube, together with the wand
(2), into the full canister (1) and screw it in place.
Make sure that the tube is routed without any kinks
and that the vent opening on the canister’s cap is open
and clear.
4.
Check to make sure that the canisters are set up
correctly:
The canisters’ location must be lower than the level
at which the appliance is resting on its base.
The contact point between the canisters and their
supporting surface must not be more than 40
inches below the bulkhead fittings.
Check to make sure that the tube is connected to the
right connection.
The rinse aid must go to appliance connection F
(indicated by a green color).
5 How to Clean the Combi Steamer
Operating Manual 99