No. Safety device Function Check
Door solenoid switch
(electrical door sensor):
Stops/turns off the
following when the
appliance door is opened:
Fan (will stop after a
few seconds)
Heating element
Cleaning agent
spraying in the fully
automatic oven
cleaning process
Prompts the user to close
the appliance door
Test the door solenoid switch
with the combi steamer at a
low temperature:
Procedure:
Fully open the appliance
door
Press Start
Result:
The motor must not start
running
4
Suction panel inside
the cooking
compartment; can only
be removed with tools
Prevents staff from reaching
into the moving fan and
ensures proper heat
distribution
Please refer to “
Releasing the
Suction Panel and Locking it
Back in Place
on page 105“
5
Integrated preheat
bridge in appliance
door
Prevents scalding caused by
escaping steam if the loading
trolley is not inside the
appliance during pre-heating
None
6
(not shown)
Safety thermostat
Boiler
Cooking
compartment
Turns off the appliance if the
temperature exceeds the
allowable limit
An error code will be output in
the event of a fault
(Contact a service company
that is authorized to reset the
safety thermostat)
7
(not shown)
Restart or forced
rinsing after power
outage if there was
cleaning agent inside
the appliance when
the power went out
Starts the fully automatic oven
cleaning process again, from
a defined state, after a power
outage
None
8
(installed by
the
customer)
Power disconnection Used to de-energize the
appliance during cleaning,
repairs, and maintenance
work, as well as in hazardous
situations
The operator does not need to
check anything.
9
(installed by
the
customer)
Gas shut-off device Used to disconnect the
appliance from the gas supply
during cleaning, repair, and
maintenance work, as well as
in hazardous situations.
The operator does not need to
check anything.
3 For Your Safety
Operating Manual 40
To Next Page
Loading...
Need help?
General
