Convotherm 4 - Page 85

5.
Add cleaning agent from the single-measure dispensing
bottles to the inside of the cooking compartment.
If necessary, remove the loading trolley from the cooking
compartment to do so and then slide it back in.
6
.
Close the appliance door.
7
.
Wait for the cleaning stage to be done (approx. 30 – 60
minutes depending on the selected cleaning profile).
If you are using easyTouch controls and you select the
“Express” cleaning duration, skip steps 8 through 12.
8.
Once the cleaning stage is done, the appliance will
make a sound to let you know.
You will be prompted to add rinse aid to the inside.
The software will indicate how many single-measure
dispensing bottles are needed.
In exceptional cases, you can skip adding rinse aid
depending on the water hardness and the degree of scale
build-up in the appliance.
9.
Open the appliance door.
1
0.
Add rinse aid from the single-measure dispensing bottles
to the inside of the cooking compartment.
If necessary, remove the loading trolley from the cooking
compartment to do so and then slide it back in.
1
1.
Close the appliance door.
1
2.
Wait for the last cleaning stage to be done (approx. 20 –
30 minutes depending on the selected cleaning profile).
1
3.
Once the last cleaning stage is done, the appliance
will make a sound to let you know.
Follow the software’s prompts.
1
4.
Open the appliance door and check to make sure that
everything has been cleaned properly. The cooking
compartment should be visibly clean and should not
give off any smells typical of food leftovers or cleaning
agents.
Check the cooking compartment to make sure that no
foreign objects got in during rinsing. If there are any
foreign objects, remove them.
If additional cleaning is required, clean and rinse the
cooking compartment manually or by running a
cleaning profile once again.
5 How to Clean the Combi Steamer
Operating Manual 85