Safety instructions
- 9 - EN
– The exhaust pipe and its cover (top
left) can reach a high temperature
–
You can get more installation
advice from the installation
instructions. For the connected
wattage, voltage and fuse rating,
see the technical data or circuit
diagram in the CONVOTHERM’s
wiring space.
• All appliance models
– To ensure that your
CONVOTHERM is working trouble-
free, maintenance should be
carried out at least once a year by
a designated customer service
department authorised by
CONVOTHERM.
–
When not using the appliance for
extended periods, shut off the
water stopcock and disconnect the
building’s electricity supply to the
CONVOTHERM.
• Cleaning
– For the purposes of cleaning, the
optional hand-held shower must
only be used for the oven interior
and not for the outer housing. Do
not spray the air intake or outlet
apertures of the CONVOTHERM.
–
Only carry out cleaning and
maintenance work on the cold
CONVOTHERM.
Do not spray water into the hot
oven.
Allow the temperature in the
CONVOTHERM’s oven to cool
down to below 60°C.
–
Regular cleaning of the
CONVOTHERM, both inside and
out and including the door
appliance drip channel, after daily
use will guarantee you years of
pleasure with your CONVOTHERM!
–
Only use CONVOTHERM
approved cleaning agents.
See section “Daily maintenance
and care”. On no account use
irritating, highly alkaline cleaners or
scourers. In the event of damage
which can be traced back to
improper cleaning, any claim under
the warranty becomes invalid!
–
Do not use jet cleaners or water
sprays to clean your
CONVOTHERM!
–
Do not treat the CONVOTHERM
with acids or expose to acid steams,
as stainless steel can then corrode.
• Decalcification of the oven
- remove light calcium films by
spraying, letting CONVOCare work
and wiping out thoroughly with a
damp cloth
- heavy calcium deposits should
only be removed by approved
CONVOTHERM authorised customer
service department
On a day to day basis
• Before switching on
–
Lock the rack as instructed.
–
If the ambient temperature at the
installation site is below +4°C heat
the CONVOTHERM up to room
temperature before initial start up.
–
After transporting the
CONVOTHERM when the outside
temperature is below -4°C, the
safety temperature limiter may
have been triggered. This has to be
corrected by a CONVOTHERM
approved electrician.
–
In the case of an “E...” error
message, refer to the section “What
to do if ...”.
To Next Page
Loading...
