Moving and setting up the appliance
Installation manual 43
Using a fork-lift truck to take the floor-standing appliance off the pallet
Observe the following points when lifting the appliance off the pallet:
Use a forklift truck or pallet truck.
Place lengths of wood underneath (1).
Make sure that the forks are in the correct position (keeping to the right of the drain outlet (C))
The following diagram shows how to take the combi steamer off the pallet:
1
C
The following table shows the distance C:
xx.10 xx.20
C
[mm] 280 320
Setting up floor-standing appliance
When setting up a floor-standing appliance, follow the steps below:
Ensure the appliance is horizontal by adjusting the height of the feet.
Use a spirit level for this task.
Make sure that the loading trolley is standing horizontally in the appliance.
The following diagram shows how to use the spirit level and adjust the appliance feet to ensure the
appliance is horizontal:
To Next Page
Loading...
Need help?
General
