CoolAutomation CoolMasterNet - Uid

ASCII I/F
CoolMasterNet PRM Rev 0.7
17
www.coolautomation.com
© 2017 CoolAutomation
14
Virtual Address In Use
Virtual address already in use
15
Bad Property
Wrong property
16
Number of lines exceeded
Can't define more line types
17
Warning! Dip Switch State Incorrect
Dip swith state is incorrect for defined line type
18
SDDP Not Initialized
SDDP is enabled, but Ethernet link is still down
80
ModBus Error:80
No response from the addressee
81
ModBus Error:81
Big timeout between bytes in received message
82
ModBus Error:82
Small timeout between bytes in received message
83
ModBus Error:83
Received message with internal timeout
84
ModBus Error:84
Received message is too big
85
ModBus Error:85
CRC error in received message
86
ModBus Error:86
ModBus exception in response
100
Collision
Collision in sent command on HVAC line
101
Unsupported Feature
Unsupported command or command's parameter for this HVAC
line
102
Incorrect Indoor Type
Chosen Indoor Unit doesn't support this command or command's
parameter
103
No ACK From Indoor
Indoor Unit didn't acknowledged sent command
104
Time Out on Receive
No response from Indoor Unit
105
CS Error In Received Message
Check Sum error in received message
106
Line Init In Progress...
Can't show lines status due to initialization process
107
Line Error
Some error on the HVAC line
108
Feed Disabled
Indoor Unit can't receive measured ambient temperature due to
its switch position
150
HDL Not Initialized
HDL line was not defined or ethernet cable is unplugged
151
HDL DB Overflow
HDL Data Base is full, can't add new configuration
152
HDL Eth Disabled
HDL over ethernet disabled
200
UID Not Found
Specified Indoor Unit not found in Data Base
201
Strict UID Not Found
Specified Indoor Unit by uid strict not found in Data Base
202
Indoor Removed
Indoor Unit removed from Data Base
203
DB Overflow
Indoor Units Data Base is full, can't add new one
204
Group DB Overflow
Group Data Base is full, can't add new group
205
VA DB Overflow
Virtual address Data Base is full, can't associate Indoor Unit with
new virtual address
206
FDB5 Overflow
Properties Data Base is full, can't add new property
250
Link DB Overflow
Link Data Base is full, can't link new CoolPlug device with Indoor
Unit
251
No CoolHub Line
CoolHub line not defined, define it to proceed
252
Auto Visibility Failed
During link creation there was an error on adding visibility props
253
Link already exists
CoolPlug device already linked, delete previous link before
creating the new one
307
KNX DB Overflow
KNX Data Base is full, can't add new group
309
KNX Not Connected
No connection with KNX chip
310
KNX Line Not Started
KNX line not defined
6.1.3 UID
UID is used to identify Indoor Unit or a set of Indoor Units. UID has the following format:
Line
Dot
Indoor Number
Ln
.
X
YY