CoolAutomation CoolMasterNet - Props

ASCII I/F
CoolMasterNet PRM Rev 0.7
25
www.coolautomation.com
© 2017 CoolAutomation
>knx group -2
OK
props
SYNOPSIS
props
props <UID_STRICT> <PROPERTY> <VAL>
DESCRIPTION
Query or change Indoor Unit(s) properties. In format without parameters props command will list all stored
properties in comfortable table.
<PROPERTY>
Mode
Value
Description
Notes
visible
R/W
0 or 1
Define Indoor Unit visibility on LCD. 0 -
invisible, 1 - visible. Also depends on filter
setting.
The property take effect after
reboot
name
R/W
string
Define Indoor Unit name to display on LCD.
Default value is no name.
When Indoor Unit doesn't
have name property the
default name in format Ln.
XYY is displayed
fspeed
R/W
<+|->v, l, m, h, t, a
Define fan speed previous/next switch options
on LCD: + allow, - forbid. Works also with fan
speed commands to/from KNX bus. v - very
low/quiet, l - low, m - medium, h - high, t - top,
a - auto
Different fan speed
properties can be
combined in one command
(see example below)
mode
R/W
<+|->c, d, f, h, hx,
hh, a
Mode properties logic not implemented yet. c -
cool, d - dry, f - fan, h - heat, hx - haux, hh -
heat & haux, a - auto
Different mode properties
can be combined in one
command (see example
below)
Notes:
Indoor Unit properties record created when defining any of the listed properties, while the rest properties receive
default values that can be overwritten later.
Bold values are defaults.
EXAMPLE
Add name property to Indoor Unit 204 on line L6
>props L6.204 name Kitchen
OK
Make Indoor Unit 102 on line L1 invisible on LCD
>props L1.102 visible 0
OK, Boot Required!
Forbid medium and auto fan speeds to Indoor Unit 107 on line L2
>props L1.102 fspeed -m-a
OK
Define cool, fan, haux modes to Indoor Unit 101 on line L1
>props L1.101 mode +c+f+hx-h-d-hh-a
OK
List all stored properties
>props
UID | Name | Visi | Modes | Fspeeds |
------- ---------------- ------ ----------------- -------------
L6.204 | Kitchen | 1 | c d f h a | l m h a |