CoolAutomation CoolMasterNet - Page 45

ASCII I/F
CoolMasterNet PRM Rev 0.7
45
www.coolautomation.com
© 2017 CoolAutomation
Full Lock
>lock L5.002 +
OK
group
SYNOPSIS
group
group <UID1_STRICT> <UID2_STRICT>
group delall
group -G
group ram R
DESCRIPTION
Control group operation in CoolMasterNet. Grouping of two Indoor Units means that second Indoor Unit will
follow ON/OFF, Mode, Fan Speed, Set Temperature and Swing settings of the first Indoor Unit.
· In format without parameters group will list existing groups
· group delall - delete all groups
· group -G - delete group number G (group numbers displayed in the list of existing groups)
· group <UID1_STRICT> <UID2_STRICT> - create new group, where UID2 will follow UID1
· group ram R - create group Data Base for R groups. The operation will take effect after reboot. Use this
operation only if default group Data Base is too small.
EXAMPLE
Group Indoor unit L5.001 with L5.002
>group L5.001 L5.002
OK
List existing groups
>group
G000: L5.001 --> L5.002
G001: L5.001 --> L5.003
OK
Delete group number 0
>group -0
OK
Delete all groups
>group delall
OK
Create group Data Base for 50 groups
>group ram 50
OK, Boot Required!
CA
SYNOPSIS
CA <Ln> [adr]
CA <Ln> ?
DESCRIPTION
In format CA <Ln> ? query centralize address of Indoor Units on line Ln (only for SA/TO/PN). In format CA
<Ln> [adr] distribute new group addresses on line Ln starting from adr, without adr the default value of 100 is
taken (only for DK).