Manuals+
User Manuals Simplified.
COOLER MASTER MWE GOLD V2 User Guide
Home » COOLER MASTER » COOLER MASTER MWE GOLD V2 User Guide
Ver 1.0 2020/09
MWE Gold V2 550/650/750/850
User Guide
Safety Instructions
Do not open the power supply unit as this can lead to serious injury or death.
Do not insert objects into the spinning fan. This will damage the power supply unit and can lead to injuries.
Do not use excessive force when attaching the power connectors to the power supply unit. When correct
connectors are used, excessive force is not needed to install them.
Keep power supply unit in dry environments away from humidity. If the power supply unit gets wet, immediately
remove the AC power plug from the wall and the power supply unit. For your own safety, it is recommended that
you do not use the power supply unit again after getting it wet.
Avoid using low-quality extension cables for the power supply side connectors as this can cause the cables to
melt and even lead to a fire.
This power supply unit has been tested for PC users only. We cannot guarantee operation or safety
performance when used for other applications.
Installing the Power Supply Unit
1. Make sure the main power switch is turned off before installing the power supply unit.
2. Secure the power supply unit within the PC case enclosure with 3 or 4 screws for grounding and stability
purposes.
3. Connect the power connectors according to the motherboard, graphics card, and other device user guides that
will be used in the system.
4. Connect the AC power connector.
5. Switch on the power switch.
To Next Page
Need help?
General
