coov N100 Plus - Page 10

b. Hold down the button that needs to turn off the burst function, and then press the
PS4 button / X1 button / NS Pro button, so that the burst function of the
corresponding button can be turned off.
c. Press the PS4 button / X1 button / NS Pro button to exit the configuration mode.
3.Elimination of all the burst
a. Press the PS4 button / X1 button / NS Pro button + PS4 button / X1 button
/ NS Pro button at the same time and release to enter the burst function configuration
mode.
b. Hold down the PS4 button / X1 button / NS Pro button for 3 seconds, all the
configured burst function will be eliminated automatically, and it will exit the configuration
mode automatically.
4.Adjust the burst frequency(Basic mode)
a. Press the PS4 button / X1 button / NS Pro button + PS4 button / X1 button
/ NS Pro button at the same time and release to enter the burst function configuration
mode.
b. Press the to Increase the burst frequency
c. Press the to reduce the burst frequency
d. Press the PS4 button / X1 button / NS Pro button to exit the configuration
mode.
5.Adjust the burst frequency(Custom mode)
In custom mode, the user can set two parameters: press time a millisecond and release
time b milliseconds. When the burst starts, the key is automatically pressed for a
millisecond, then released for b milliseconds, and then pressed a millisecond for a round
trip. The values of a and b should be greater than 4 and less than 252.
a. Determine the value you want to set, such as a is 128, b is 164
b. Press the PS4 button / X1 button / NS Pro button + PS4 button /
X1 button / NS Pro button at the same time left and release, enter the serial
configuration mode