coov N100 Plus - Joypad Vibration Switch and Force Adjustment Function; Four Sets of Independent Configuration Switching

configured infinite loop function will be eliminated automatically, and it will exit the
configuration mode automatically.
4. Start/stop infinite loop
a. Press the button that has set the infinite loop function to enter the infinite loop state.
b. Press this button again to exit the infinite loop state
5. Button supported
All the buttons except PS4 button / X1 button / NS Pro button, PS4 button /
X1 button / NS Pro button,PS4 button / X1 button / NS Pro button and the
rocker.
E
、
Joypad vibration switch and force adjustment function
a. Simultaneously press PS4 button / X1 button / NS Pro button +
PS4 button / X1 button / NS Pro button and release to enter vibration
configuration mode
b. Click the s to improve the vibration intensity
c. Click the , reduce the vibration intensity (to a minimum, turn off the vibration)
d. Press the PS4 button / X1 button / NS Pro button to exit the configuration mode
DS3 handle can not adjust the vibration intensity, only the switch function
F
、
Four sets of independent configuration switching
The V5.0 firmware can save 4 sets of configurations at the same time, and the first set of
configurations is loaded by default when booting. The configurations between the groups
do not interfere with each other and can be quickly switched using PS4 button /
X1 button / NS Pro button + PS4 button / X1 button / NS Pro button
or PS4 button / X1 button / NS Pro button + PS4 button / X1 button /
NS Pro button. LEDs (red, green, blue, yellow) and vibration prompts when
switching.
Use scenarios such as: