Corghi CompactLine EM 9250 - Main Features

82 EM 9250 Operator’s manual
Key to caution and instruction labels
Never use the wheel spin shaft as a lifting point for the machine.
Unplug the power supply plug before performing any maintenance/
repair operations on the machine.
Do not lift up the guard when the wheel is turning.
Please use centring accessories with hole diameter 40 mm.
MAIN FEATURES
- Low balancing speed:
• minimiseswheelspintimes;
• reducesriskduetorotatingparts;
• savesenergy.
- Automatic sensor for distance and diameter measurement.
- Automatic mechanical sensor for width measurement (if present).
- AWD (Auto Width Device) programme for measuring the width using an ultrasonic sensor
(if present).
- AWC” (Auto Width Calculation) programme for enabling the manual insertion of the
width (if present).
- Automatic brake for stopping the wheel at the end of the spin.
- Wheel-holder shaft locking brake.
- STOP button to stop the machine immediately.
- Side flange holders.
- Top tray to take weights of all types.
- Automatic start by lowering the guard.
- Luminous digital display unit double display and 3D graphics.
- Microprocessor processing unit (16 bit).