Corghi CompactLine EM 9250 - Display Panel - Control Keypad

EM 9250 Operator’s manual 89
UK
DISPLAY PANEL - CONTROL KEYPAD
KEY DESCRIPTION
1
Wheel dimen-
sions
- Press this key to manually enter the wheel dimen-
sions in the case of an automatic measurement
system malfunction or for versions with a manual
internal sensor.
2
End / Esc
Multifunction key
1. In balancing mode, press this key to temporar-
ily display the value rounded to the gram or
1/10 of ounce.
Note: for ALU1P and ALU2P balancing pro-
grams with shift plane, this key is not enabled.
2. In a menu or in a program, press this key to exit.
3
Internal weight
selection/De-
crease
Multifunction key
1. In balancing mode, press this key to select the
type of weight to use on the inner side of the
wheel.
2. In the menu press this key to navigate.
3. When entering dimensions manually, press this
key to decrease the displayed value.
4
Menu / Enter
Multifunction key
1. In balancing mode, press this key to access the
wheel balancer menu.
2. In a menu or in a program, press this key to
change the viewed option.
5
Outer weight
selection/In-
crease
Multifunction key
1. In balancing mode, press this key to select the
type of weight to use on the outer side of the
wheel.
2. In the menu press this key to navigate.
3. When entering dimensions manually, press this
key to increase the displayed value.
6
Start
- Press this key to perform a spin with the wheel
guard lowered.
- Searches for another side (with RPA active and
wheel guard open).
7
Stop - Press this key to stop the spin.