Corghi CompactLine EM 9250 - Technical Data

EM 9250 Operator’s manual 83
UK
-Resolution:1g(1/10oz).
- Wide selection of programmes making the machine easy to use.
- Unbalance value display in grams or ounces.
- Unbalance display rounding-off setting.
- Balancing modes available:
• Standard dynamic on both rim sides
• Alu/AluP seven different routines for alloy rims
• MotorcycleMotorcycle dynamic on both sides for motorcycle rims
• MotorcycleALU dynamic on both sides of alloy motorcycle rims
• Static on a single side.
- “Shift planes” programme (in Alu P) for using multiple five gram weights, i.e.: available
without the need for partial cuts.
- “Hidden Weight” programme (in Alu P) in order to divide the outer side balancing
adhesive weights into two equal weights positioned behind the spokes of the rim.
- “Split Weight” programme (motorcycle programmes) to divide the weight into two
equivalent values to be placed on either side of the spoke.
- “OPT flash” programme for rapid optimisation of operating noise reduction.
- “FSP” (Fast Selection Program) programme for the automatic selection of the balancing
programme.
- General utility programmes:
• calibration
• service
• diagnostics.
- Independent working environments that allow a maximum of two operators to work in
parallel with no need to reset any data.
- RPA: automatic wheel positioning in the position where the balancing weight has to be
applied (if present).
- Possibility to select the position for applying the adhesive weight:
• Vertical plane in the lower part of the wheel (H6) using the LASER line
• Vertical plane in the upper part of the wheel (H12)
• CLIP: using the weight-holder terminal in the ALUP balancing programmes (in all the
other H12 balancing programmes)
- LED light (if present).
- LASER indicator (if present).
TECHNICAL DATA
- Single-phase power supply voltage ................. 100/115±10%,200/230V±10%,50/60Hz
- Rated power ................................................................................................................... 100 W
- Rated current ...................................................................1 A at 100-115V, 0.5A at 200-230V
- Balancing speed ....................................................................................................90/130 rpm
- Maximum unbalance value calculated ................................................................ 999 grams
- Average spin time (with 5”x14” wheel) ......................................................................... 7 sec
- Shaft diameter .............................................................................................................. 40 mm
- Ambient work temperature ....................................................................................5°to40°C