EM 9250 Operator’s manual 115
UK
- use the keys to search for SEt UP
- press the key to confirm
- use the keys to search for ALU P (or ALU St if previously set)
- press the key to change the setting:
or ALU P: to activate the ALUP balancing programmes. These programmes are used for
maximum precision balancing on light aluminium rims that require the application of both
weights on the same side (inner) in relation to the rim disk. This type of wheel balancer is
particularly suitable for application of adhesive weights on the rim, thanks to the forward
positionofthewheelinrelationtothebody,whichallowsalargezoneontheinsideof
the rim to be accessed freely. To enter the dimensions and apply the weights, refer to the
paragraphs with ALU 1P – ALU2P
or ALU St: to memorise the rated dimensions of the rim. Self-adhesive weights are gener-
ally used to balance alloy wheels and are applied differently than for standard balancing.
Several ALU balancing programmes are available, specially designed for these types of rim.
To enter the dimensions and apply the weights, refer to the paragraphs “Entering wheel
dimensions (ALU1P and ALU2P programmes excluded)” and “Applying balancing weights”
- press the key to confirm and exit.
15.3. SET UP - UNBALANCE UNIT
OF MEASURE
The machine may be set to display the unbalance values in grams or ounces. Proceed as
follows to modify this configuration:
- press the key
- use the keys to search for SEt UP
- press the key to confirm
To Next Page
