EasyManua.ls Logo

cormidi 80 Series - 4.2. Motor; 4.2.1. Pre-filter and Air Filter in an Oil Bath

Default Icon
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Series 65-80
46
3.15. STORAGE
Whenever the machine must remain inactive for
several months, it is necessary to provide a correct
garaging so that the machine is in perfect working order
when it is used again.
In particular one must carry out storage by following
all of these instructions:
Carry out all necessary repairs;
Disconnect the battery, turning the device to cut off
battery;
Empty the fuel tank completely;
Proceed with a careful cleaning and remove all
mud, and/or organic residues carefully;
Proceed with all operations regarding the motor that
are described in its own manual;
Carry out a greasing of all points listed in the
specific chapter;
Place the machine in such a way that it is sheltered
from atmospheric agents under stable conditions
and on a flat surface;
If the machine is equipped with batteries, unplug
them and lubricate with the correct grease;
Periodically, every two months, recharge the
battery;
If the motor is equipped with a start-up key, take it
out and conserve in a safe place.
When putting the machine back into service:
carry out all greasing again in all prescribed points
found in the specific chapter;
If the machine is equipped with a battery, recharge
it and reconnect it being certain of the correct
polarity of the ends;
Insert the cut off battery lever;
Proceed with the operations concerning the motor
described in its own manual;
Check the oil level and add some if necessary.

Related product manuals