Cornwell Tools CTG2000ANG - SET UP; POWER ON AND RESETTING; SLEEP MODE; LOW BATTERY VOLTAGE PROTECTION

CTG2000ANG/CTG3000ANG/CTG5000ANG 4 Rev. 03/15/17
• Press to power on the digital torque wrench.
• If the wrench does not function normally, remove the
battery cover, then replace. This will reset the unit.
NOTE:
If an external force is being applied to the torque
wrench during power-on/reset or wake up period, an
initial torque will be shown in the display. Some or all
the lights will illuminate and the wrench will sound a
continuous alarm tone.
To clear the display and stop the alarm press the
button.
NOTE:
When using the wrench in "ANGLE" mode the wrench must be placed flat (horizontally) on table or workbench
before any attempt is made to change values or to power up the unit.
If the user attempts these functions without following the instructions above the unit's display will begin to flash a
series of four zeros in the top half of the screen.
In order to reset the unit; remove the battery cover, then replace.
POWER ON AND RESETTING
IMPORTANT!
LOW BATTERY VOLTAGE PROTECTION
Battery Indicator
SLEEP MODE
• The wrench will automatically go into "Sleep" mode
after being idle for approximately 2 minutes to save
power.
Press to wake from "Sleep" mode.
SET UP
1
4
32
1. Power On/Clear
2. Unit/Setting
3. Memory (Stores up to 9 values)
4. Up/Down
• If the battery voltage is below 2.3 volts, the wrench
will highlight the battery symbol and after a few
moments turn off.
WARNING WARNING
Angle Mode Warning