Cornwell Tools CTG2000ANG User Manual

CTG2000ANG/CTG3000ANG/CTG5000ANG 11 Rev. 03/15/17
TROUBLESHOOTING
Error Codes for Angle Feature Torque Wrenches
Error Code Cause Corrective Action Comments
1. Press the button to restart
the torque wrench - If this does not
work, then
2. Remove battery cap - then
reinstall. Press the button to
restart the torque wrench.
1. Press the button to restart
the torque wrench - If this does not
work, then
2. Remove battery cap - then
reinstall. Press the button to
restart the torque wrench.
1. Press the button to restart
the torque wrench - If this does not
work, then
2. Remove battery cap - then
reinstall. Press the button to
restart the torque wrench.
Applied torque exceeded 110%
of the maximum rated capacity
of the torque wrench.
Return torque wrench to repair
center for calibration.
The torque wrench shut down
during angle mode. When
restarted, the torque wrench
was not laying horizontally.
Angle module communication
failure.
Rotational speed of the torque
wrench was exceeded.
Note 1.
If the torque wrench is shut down while in angle mode, then restarted while not horizontal, four flashing zeros
may appear in the display . Follow the same steps listed above for ER4 error code.
See also "Angle Mode Warning" on page 4 of the manual to review correct procedures for
changing the angle values.
If the torque wrench
is in angle mode, it
must be laying in the
horizontal position
when turned on.
If the torque wrench
does not restart or
continues to show the
ER5 error code, it
should sent to the
repair center.
Rotational speed of
the torque wrench
should not exceed 30º
per second.
(See note 1.)

Cornwell Tools CTG2000ANG Specifications

General

Brand	Cornwell Tools
Model	CTG2000ANG
Category	Power Tool
Language	English