4-26
Section 4
Shallow Alarm
This alarm sounds when the water depth equals or is less than the
set value.
The display will show “S X.X” which is the current setting for the
shallow alarm. Pressing s and t will change the shallow setting.
Holding M in for two seconds will save the new shallow setting and
change the display back to the normal depth mode. Set to zero to
disable the alarm.
Deep Alarm
This alarm sounds when the water depth equals or is greater than
the set value.
The display will show “d XX.X” which is the current setting for the
deep alarm.
Pressing s and t will change the deep setting.
Holding M in for two seconds will save the new deep setting and
change the display back to the normal depth mode. Set to zero to
disable alarm.
To Next Page
Loading...
