Cleaning of rotor
When required, yearly or after use in very dirty environment, it is recommended to clean the rotor
with pressurized air. The rotor can be clogged by dirt resulting in lowered air flow and capacity. To
clean the rotor, follow these instructions:
When the rotor shall be cleaned, the dehumidifier must be disconnected from power.
Always use a suitable protective mask and stand outdoors when cleaning the rotor.
Make the machine powerless.
Remove the four screws that hold the top lid
of the dehumidifier.
1. Gently lift the lid enough to reach and
disconnect the three cable connectors that
are positioned along the front of the
machine.
Note: The connectors have clamps that lock
them into place and these need to be pushed
while the connector is pulled out.
To Next Page
Loading...
