34
XXXXX XXXXX
33
7. Tighten Belt
Place hand in child restraint.
Firmly push down and towards the
vehicle seat back while
pulling free end of belt to tighten.
It may be easier to pull back the
pad and tighten the belt through
the belt path opening as shown.
8. Check Belt Tightness
Hold child restraint at the belt path
with your weakest hand.
Push and pull from side to side.
It should not move more than
1 in. (2.5 cm).
6. Attach Lower Anchor
Hooks to Vehicle’s
Lower Anchors
Review your vehicle owner’s
manual for lower anchor locations
and lower anchor belt use.
5. Place Child Restraint
Rear Facing in Back Seat
For children between 5-22 lb
(2.3-10 kg), the bottom level line
on shell
MUST be parallel with the
ground.
For children 22-40 lb (10.1-18
kg) who can sit up unassisted,
rotate the child restraint between
the 2 level lines.
Start by making the bottom level
line be parallel with the ground,
then rotate seat up. Do not rotate
past the top level line.
3. Reach Under Pad and
Pull Lower Anchor Belt
Across to Opposite Side
Do not twist belt.
Belt MUST be in front of buckle
strap and under seat pad.
You
MUST use the 1st or 2nd
buckle slot.
4. Finished Lower Anchor
Routing
If it moves more than 1 in. (2.5 cm), you can try:
A. Pulling the belt tighter. B. Reinstalling the child restraint.
C. Changing to a different seating location. D. Switching to
vehicle belt installation.
continued on next page
To Next Page
Loading...
