8
XXXXX XXXXX
Changing Position of Shoulder Harness
Straps
7
1. Fully Loosen Harness
Straps
2. From Back, Remove
Harness Strap Loops
From Splitter Plate
3. Pull Harness Straps Out
of Shoulder Harness
Slots
4. Rethread Harness Straps
into Correct Shoulder
Harness Slots For Your
Child
If you will be using the lowest shoul-
der harness slots, you
MUST adjust
the harness straps.
See pages 10-12.
WARNINGS: Make sure that the harness height is
correct for your child’s size.
Do not use this child restraint rear facing
unless the top of your child’s head is at least
1 in. (2.5 cm) below the top of the child
restraint.
Do not use this child restraint forward facing if
the tops of your child’s ears are above the top of
the child restraint.
Failure to follow these steps can result in serious
injury or death.
5. Attach Harness Strap
Loops to Splitter
Plate As Shown
Sewn ends of the harness strap
loops
MUST face towards you.
DO NOT twist harness straps or
harness adjustment strap.
Make sure the harness strap loops
are fi tted COMPLETELY ON both
sides of the splitter plate.
To Next Page
Loading...
