20
INSTALLATION INSTRUCTIONS
IMPORTANT: This appliance shall be installed only by authorized persons and
in accordance with the manufacturer's installation instructions, local gas
fitting regulations, municipal building codes, electrical wiring regulations,
local water supply regulations.
UNPACK RANGE
NOTES:
1. Remove shipping materials, tape and film from the range. Keep
cardboard bottom under range. Do not dispose of anything until the
installation is complete.
2. Remove oven racks and parts package from oven and shipping materials.
3. To remove cardboard bottom, first take 4 cardboard corners from the
carton. Stack one cardboard corner on top of another. Repeat with the
other 2 corners. Place them lengthwise on the floor behind the range to
support the range when it is laid on its back.
4. Using two or more people, firmly grasp the range and gently lay it on its
back on the cardboard corners.
5. Remove cardboard bottom.
• The leveling legs can be adjusted while the range is on its back.
• To place range back up into a standing position, put a sheet of
cardboard or hardboard on the floor in front of range to protect the
flooring. Using two or more people, stand range back up onto the
cardboard or hardboard.
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
To Next Page
Loading...
Need help?
General
