42
Regulator
Cap
Orifice
Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner grates, burner caps, and the burner base.
3. Remove the natural gas orifices with a 9/32" (7 mm) nut driver.
6. Turn the retainer pin upside down and place it back into the regular cap.
The regular cap is now positioned for use with LP gas.
7. Screw and tighten the regulator cap back into the gas pressure regulator
with the wrench.
Propane gas
position
To Next Page
Loading...
