A temperature fault or warning has occurred
A communications, memory or logic fault has occurred
A fault or warning not listed in bits [7:1] has occurred
STATUS_WORD (0x79)
Command returns the general status information used to indicate
subsequent status to be read for more detail.
An output voltage fault or warning has occurred
An output current or output power fault or warning has
occurred
An input voltage, input current, or input power fault or
warning has occurred
A manufacturer specific fault or warning has occurred
The POWER_GOOD signal, if present, is negated¹
A fan or airflow fault or warning has occurred
A bit in STATUS_OTHER is set
A fault type not given in bits [15:1] of the STATUS_WORD
has been detected
A fault was declared because the device was busy and
unable to respond.
This bit is asserted if the unit is not providing power to the
output, regardless of the reason, including simply not
being enabled.
An output overvoltage fault has occurred
An output overcurrent fault has occurred
An input under voltage fault has occurred
A temperature fault or warning has occurred
A communications, memory or logic fault has occurred
A fault or warning not listed in bits [7:1] has occurred
To Next Page
Loading...