Cleaning the Neo-Sense Filter 11 inch (S) (for installation and replacement):
Clean the Neo-Sense Filter 11 inch (S) for about 30 seconds.
Cleaning the Post-Carbon block Filter 8 inch (S) (for installation and replacement):
Clean the Post-Carbon block Filter 8 inch (S) for about 3 minutes.
- For initial installation, flush the Post-Carbon block Filter 8 inch (S) before installing it.
(Flushing the Post-Carbon block Filter 8 inch (S) during the initial installation minimizes the inflow
of fine particles into the water tank.)
Cleaning the Neo-Sense Filter and Post-Carbon block Filter
- Remove the tubing from the bottom of the Neo-Sense Filter 11 inch (S).
- Connect the Post-Carbon block Filter 8 inch (S) to the bottom of the Neo-Sense Filter 11 inch (S).
- Clean the Post-Carbon block Filter 8 inch (S) with the water coming from the Neo-Sense Filter
11 inch (S) for about 3 minutes. (Water flow rate 300~500
㎖/min)
- Separate the Post-Carbon block Filter 8 inch (S) from the Neo-Sense Filter 11 inch (S) and then
connect it to the bottom of the Membrane Filter (RO) 11 inch.
To Next Page
Loading...
Need help?
General
