1-2 Precautions on installation
1. Do not install the product where the unit is exposed to direct sunlight or heating devices.
- Otherwise product deformation or fire may occur as a result.
2. Do not install the unit in areas where moisture, water (rainwater) is present.
- Otherwise electric shock or fire may occur as a result. (P-07QR only )
3. Do not operate the unit in areas where flammable gases or combustible materials are used or
stored.
- Otherwise fire may occur as a result.
4. Install the unit on a level area and do not exert excessive force or shock on the unit.
- Otherwise product damage or malfunction may occur as a result.
5. Use tap water as feed water.
6. Do not connect the water inlet to the warm water supply piping.
- Otherwise malfunctions or accidents may occur as a result. (Make sure to connect to cold tap
water supply piping.)
7. The length of the water inlet hose must be 5m or less.
- If it is longer, it may degrade the product’s performance.
8. The length of the water outlet hose must be 25cm or less.
- If it is longer, it may degrade the product’s performance, and prevent complete drainage of water.
9. Proper places to install the unit
- The water purifier stays away 10cm or more from the wall and install without shaking in the flat
place. If the unit is installed in an unstable place, the system may not function properly.
To Next Page
Loading...
Need help?
General
