No. Explanation Reference picture
1
1) Close main water supply valve to separate the
faucet.
2
1) Wind the teflon tape on the adaptor and fit it to
the pipe.
Do not turn the water pipe.
3
1) Connect the faucet with the adaptor.
Shall install the adaptor with connector on the
cold water pipe.
4
1) Connect ¼ inch orange tubing with the
connector on the adaptor.
Flush water through each filter at least 5
minutes before Connection.
5
1) Connect it to voltage rating that matches it on
the rating plate. Then, open the feed valve to
supply water to the filtration system.
To Next Page
Loading...
