Product installation
3-2
Coway co., Ltd
3-2 Installation method
3-2-1 Precautions on installation
The water tank capacity of this water purification system has been designed for home use. It is
prohibited to install the system for medium/large business or public use. (If the water purification
system is used beyond its capacity, a water shortage and/or shortened filter life may occur as a
result.)
Install the product at least 10 cm away from the wall and on a firm and level floor.
Installation water pressure
- P-220R: A tap water pressure of 69 kpa or more
- P-220L: The feed water supply pressure should be at least 137 kpa for the purification system to
work properly, to provide enough purified water.
The Installation distance from the tap water supply
- If the tap water pressure is 137 kPa or less
:
The height should be less than 3 m and the distance should be less than 5 m.
- If the tap water pressure is 137 kPa or more
:
The height should be less than 3 m and the distance should be less than 25 m.
Do not install the system in a location exposed to direct sunlight, freezing temperatures or excessive
moisture.
If the system is installed for the first time or is being relocated, read the User Manual again before
installation.
Only connect the power cord to the voltage rating that matches it on the rating plate.
Make sure to connect the feed water inlet hose to the cold water pipe.
- If the feed water inlet hose is connected to the warm water pipe with a water temperature of 40 °C
or higher, the filters may be damaged.
Immediately after the installation, fill the water tank and drain the water.
Repeat at least twice before use.
To Next Page
Loading...
Need help?
General
