1-2 Precautions on installation
1. Do not install the product where the unit is exposed to direct sunlight or heating devices.
- Otherwise product deformation or fire may occur as a result.
2. Do not install the unit in areas where moisture, water(rainwater) is present.
- Otherwise electric shock or fire may occur as a result.
3. Do not operate the unit in areas where flammable gases or combustible materials are used or stored.
- Otherwise fire may occur as a result.
4. Install the unit on a level area and do not exert excessive force or shock on the unit.
- Otherwise product damage or malfunction may occur as a result.
5. Use tap water as feed water.
6. Do not connect the water inlet to the hot water supply pipe
- This may result in a problem with the product or an accident. (Make sure to connect it to the cold
water supply pipe.)
7. Make sure that the feed water inlet hose connected to the product from the feed water supply valve is
5m or less.
- Failing to do so may result in a performance degradation of the product.
8. Do not install the potable water drain hose at a height of 25 cm or more from the bottom of the
product.
-
This may result in a performance degradation of the product or there may be some additional
water as a result.
9. Proper places to install the unit
- Install the unit firmly on a level area. If the unit is installed in an unstable place, the system may
not function properly.
To Next Page
Loading...
Need help?
General
