Coxo C-SMART-1 Pro - Functional Check of the Apex Locator; Calibration; Factory Default Parameters; Maintenance, Cleaning and Disinfection

Problem
Cause
Solution
The power is
not turned on.
The battery is bad .
Change the battery .
The motor
handpiece
does not rotate
The motor handpiece or the
motor handpiece cord Is
damaged.
Contact your distributor.
The contra-angle is clogged.
Clean or replace the
contra-angle.
There is a short circuit inside
the motor handpiece or the
motor handpiece cord.
Contact your distributor.
Apex
measurement
is not correct.
The file has no contact with
the handpiece or file holder
correctly.
Check the connection
between the file and the file
holder , clean it if necessary.
Motor or test wire is not
properly connected.
Check the connection.
File blocks in
the root canal.
Wrong file setting.
Too much pressure on the
instrument.
Change the rotational
direction. Start the motor
and pull out the file carefully.
File not frequently cleaned.
Clean the file frequently.
8_3 Operation· ........................ ······· ........................ ·· ·14
8.3.1 M2 Apex locator only(without motor.)· .......................... 14
0 Troubleshooting
C-SMART-1 Pro Uoer Manual
8.3.2 M2 Motor only (without apex locator )·························· ·22
8.3.3 M3 Motor and Apex locator (Dual mode)······················ ·28
8.4 Functional check of the apex locator······························· · 31
8.5 Calibration .................... ········· ........................ ······ 33
8.6 Factory Default Parameters- ...... ········· ........................ · 36
If the device is not working properly , please check the following table before
calling our service center.
9 Maintenance, Cleaning and Disinfection············ ·37
9.1 Genera l ................... ········ ....................... ········ ..... 37
9.2 Cleaning, Disinfection and Sterilization··························· · ·38
(according to DIN EN ISO 17664)
9.2.1 Pre-treatment·················································· · 38
9.2.2 ManualCleaning and Disinfection····························· ·38
9.2.3 Inspection/Maintenance ....................................... 38
9.2.4 Packing· ...... ········· ........................ ········· ........ 39
9.2.5 Sterilization· .................. ········· ...................... ··· 39
9.2.6 Storage ......................................................... 40
9.2.7 Material Resistance············································ 40
10 Troubleshooting ········· .. · .. ··· ...... ·· ...... ·· .. · .. 41
11 Guarante e . ........................................... 42
12 Technical services .................................. ·42
Ill