Coxo C-SMART-1 Pro - How to Connect Each Part; Connecting and Disconnecting the Motor Handpiece; Connecting and Disconnecting the Contra Angle; Inserting and Removing the Lighting Device

C-SMART -I Pro Usar Manual
C-SMART-1 Pro Uoar Manual
7.3 How to connect each part
CAUTIONS
Do not pull on the wire when removing the part with the wire.
L
.
_
i
error
7.3.1Connecting and Disconnecting the Motor Handpiece
a. Connecting
Align the-- mark of the cord plug with the notch of the motor handpiece
socket (see Fig.)()()() at the left side of the device and insert the plug unti l it locks.
b. Disconnecting
Hold the plug ring and pull it out. Do not twist in any direction.
7.3.2 Connecting and Disconnecting the Contra angle
a . Connecting
The contra angle can be connected at 6 adjustable head positions.Align
the positioning pins of the contra angle with the positioning slots of the
motor handpiece and insert the head until it clicks.
b. Disconnecting
When removing the contra angle, pull it straight out.
CAUTIONS
• When connecting and disconnecting the contra angle, turn the power off
beforehand.
• Check that the contra angle is securely assembled to the motor handpiece.
Fig.39 Contra-angle is OK
Fig. 40 Contra-angle is ERROR
!Lt. CAUTION
ERROR message indicates that the contra-angle is not operating properly
Please contact your local dealer or contact the factory directly for assistance
r::.7' NOTE
Should you at any time wish to stop the calibration process, turn the power oft.
Calibrate every time the contra angle is lubricated or replaced after sterilizing ,
or at least once a week (Lubricating the Contra angle , Cleaning ,Disinfection
and Sterilization see the operation manual of contra angle).
Do not touch or apply a load to the contra angle chuck during calibration.
7.3.3 Inserting and Removing the lighting device
a. Inserting
Insert the lighting device into the motor handpiece(Fig.2), clamp the contra
angle and file ( Fig.3 ) .
Fig.2 Fig.3