CPS FA1000 SERIES - Recover Mode

OPERATING INSTRUCTIONS FOR THE FA1000
RECOVER MODE: The Recover/Recycle mode would be chosen to recovery refrigerant from an Auto A/C system that
needs a refrigerant containing component replaced such as a compressor, evaporator, orice tube, condenser, etc….
IMPORTANT: Before starting the recover of the refrigerant, a refrigerant identier should be used to to determine the type and purity
of the refrigerant. Failure to properly identify the refrigerant could potentially expose the user to danger from ammable refrigerants
and health hazards from toxic refrigerants. Cross contamination of refrigerants can also occur and would require special handling of
the refrigerant.
From the Main Menu screen,
Push the RECOVER key.
MAKE CERTAIN HOSES ARE
CONNECTED AND VALVES ARE
OPENED. THEN PRESS [START]
*TANK CAPACITY
REMAINING
26.00 LBS
START >
QUIT >
RECOVERY IN PROGRESS, PLEASE
WAIT
RECOVERED
1.00 LBS
TANK CAPACITY
REMAINING
25.00 LBS
QUIT >
When the unit reaches approximately 20" hg. vacuum.
The LCD will now read.
The unit will proceed to drain the recovered oil:
RECOVERY COMPLETE
RECOVERED
2.00 LBS
DRAINING OIL
00:00:45
PLEASE WAIT
QUIT >
RECOVERY COMPLETE
RECOVERED
2.00 LBS
TO VACUUM >
QUIT >
Record the RECOVERED weight reading on the LCD. Push the QUIT key to return to MAIN MENU (as shown below) or PROCEED TO
EVACUATE key for evacuation operation. Do not forget to measure the A/C oil in the oil drain bottle for future A/C oil re-injection.
RECOVER/RECYCLE Operation is now complete.
SELECT MODE
RECOVER >
EVACUATE >
CHARGE >
FULL CYCLE >
TANK REFILL >
The LCD will now read:
Push the START key.
The LCD will now read:
The unit is now recovering refrigerant.
The LCD will show the amount of refrigerant recovered.
* TANK CAPACITY REMAINING - is the amount of space available in storage tank.
SELECT MODE
RECOVER >
EVACUATE >
CHARGE >
FULL CYCLE >
TANK REFILL >
8