5. Adjust weights by lowering them, as needed, to allow for more
pressure when necessary.
6. When you are ready to stop using the machine turn the throttle
knob clockwise completely to reduce RPMs before depressing the E-
Stop button to turn o the machine.
7. Return any weights used to the upright position.
IMPORTANT! Always make sure that the weights are returned
to their original, upright position before transporting and/or storing
the machine.
8. Tilt machine up and change tools or exchange plates. (See Photo
and Warning below.)
9. Turn knob on propane valve completely to the o position and
store as appropriate.
WARNING: Plates will be HOT!
Wear safety gloves when changing plates to prevent injury.
*
HOW TO OPERATE THE MACHINE
24/7 Technical Support- Toll Free 1-877-472-8200
17
Concrete Polishing Solutions- G-250XTP Operator’s Manual
To Next Page
Loading...